Netgear WNDAP380Rv2 Manuel d'utilisateur télécharger pdf (Page 12)

Table 1. Top panel LEDs

Item LED Description

Power/Test Off Power is off.

On (green) Power is on.

Amber, then blinking

green

A self-test is running or software is being loaded.

During startup, the LED is first steady amber, then

goes off, and then blinks green before turning steady

green after about 45 seconds. If after one minute the

LED remains amber or continues to blink green, it

indicates a system fault.

Active Off No Ethernet traffic is detected, or no link is detected.

On or blinking (green) Ethernet traffic is detected.

LAN Off No link is detected on the LAN port.

Amber 100 Mbps or 10 Mbps link is detected on the LAN port.

Green 1000 Mbps link is detected on the LAN port.

4 2.4 GHz WLAN Off Wireless 802.11b/g/n (2.4 GHz) LAN is not ready, or

no wireless activity is detected.

On or blinking (green) Wireless 802.11b/g/n (2.4 GHz) LAN is ready, or

wireless activity is detected.

5 5 GHz WLAN Off Wireless 802.11n/a (5 GHz) LAN is not ready, or no

wireless activity is detected.

On or blinking (green) Wireless 802.11n/a (5 GHz) LAN is ready, or wireless

activity is detected.

Introduction

ProSAFE Dual Band Wireless-N Access Point with RFID Support, WNDAP380R

Rear Panel

Figure 2. Rear panel

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 151 152

Pas de commentaire

Netgear WNDAP380Rv2 Manuel d'utilisateur Page 12