Netgear WAC120 Guide d'installation

InstallationTrademarksNETGEAR, the NETGEAR logo, and Connect with Innovation are trademarks and/or registered trademarks of NETGEAR, Inc. and/or its s

7Change the admin Password ¾ To change the admin password:1. Launch a web browser.2. Enter http://192.168.0.100 in the address field of the browser.A

8change them. The web management interface of the access point displays.5. Select Wireless Settings. The Security Options section of the screen displ

9Problem Cause Possible SolutionYou cannot configure the access point from a browser.Multiple causes.•Make sure that the access point is correctly inst

10

11

SupportThank you for selecting NETGEAR products. Aer installing your device, locate the serial number on the label of your product and use it to regi

ContentsSet Up the Access Point... 1Install Your Access Poin

1Set Up the Access PointBefore you can use the access point you must connect to the access point and configure the LAN and wireless access settings. ¾

2 ¾ To configure the LAN and wireless access settings:1. Log in to the access point.2. Select Configuration > IP > IP Settings.3. Configure the

3Make sure that your modem is cabled only to the wall jack for your Internet service.2. Connect your devices.a. Plug in, then turn on your gateway o

4a. Connect the power adapter to the access point and plug the power adapter into an outlet.b. Wait for the Power LED on the front panel to light a

5LED DescriptionLAN LED •O. No link is detected.•Green. A 1000 Mbps link is detected.•Amber. A 100 Mbps or 10 Mbps link is detected. WiFi LED •O

6on the computer or WiFi device that you want to connect to your access point.This utility scans for WiFi networks in your area.2. Find and select yo