Netgear WNDAP380Rv2 Manuel d'utilisateur télécharger pdf (Page 110)

Monitoring

110

ProSAFE Dual Band Wireless-N Access Point with RFID Support, WNDAP380R

The following table explains the fields of the System screen:

Setting Description

Access Point Information

Access Point Name The NetBIOS name. For information about how to change the default name, see

Configure Basic General System Settings and Time Settings on page 20.

Ethernet MAC Address The MAC address of the wireless access point’s Ethernet port.

Wireless MAC Address

for 2.4GHz

The MAC address of the wireless access point’s 2.4 GHz radio.

Wireless MAC Address

for 5GHz

The MAC address of the wireless access point’s 5 GHz radio.

Country / Region The country or region for which the wireless access point is licensed for use. For

information about how to change the country or region, see Configure Basic General

System Settings and Time Settings on page 20.

Note: It might not be legal to operate this wireless access point in a country or region

other than one of those identified in this field.

Firmware Version The version of the firmware that is installed.

Serial Number The serial number of the wireless access point.

Current Time The current time. For information about how to change the time settings, see

Configure Basic General System Settings and Time Settings on page 20.

Current Settings

For information about how to change any of these IP settings, see Configure the IP Settings on page 21.

IP Address The IP address of the wireless access point.

Subnet Mask The subnet mask for the address of the wireless access point.

Default Gateway The default IP gateway for the wireless access point communication.

DHCP Client Enabled indicates that the current IP address was obtained from a DHCP server on

your LAN network. Disabled indicates a static IP configuration.

Current Wireless Settings for 802.11b, 802.1

1g, or 802.11ng

and

Current Wireless Settings for 802.11a or 802.1

1na

Note:

The section heading depends on the configured wireless mode.

Access Point Mode The operating mode of the wireless access point. One of the following modes is

indicated:

• Access Point

• Point-to-Point Bridge

• Point-to-Point Bridge with Access Point

• Multi-Point Bridge with/without client association

For information about how to change the mode, see Configure Wireless Bridging on

page 88.

1 2 ... 105 106 107 108 109 110 111 112 113 114 115 ... 151 152

Commentaires sur ces manuels

Pas de commentaire

Netgear WNDAP380Rv2 Manuel d'utilisateur Page 110

Commentaires sur ces manuels

Produits connexes et manuels pour Points d'accès WLAN Netgear WNDAP380Rv2