Netgear WNDAP380Rv2 Manuel d'utilisateur télécharger pdf (Page 11)

Introduction

ProSAFE Dual Band Wireless-N Access Point with RFID Support, WNDAP380R

• Packet fragmentation and reassembly

• Auto or long preamble

• Roaming among wireless access points on the same subnet

Autosensing Ethernet Connections with Auto Uplink

The wireless access point can connect to a standard Ethernet network. The LAN interface is

autosensing and capable of full-duplex or half-duplex operation.

The wireless access point incorporates Auto Uplink technology. The Ethernet port

automatically senses whether the Ethernet cable plugged into the port should have a

“normal” connection such as to a computer or an “uplink” connection such as to a switch or

hub.

That port then configures itself correctly. This feature also eliminates any concerns

about crossover cables, as Auto Uplink accommodates either type of cable to make the right

connection.

Hardware Description

This section describes the top and rear hardware functions of the wireless access point.

• Top Panel

• Rear Panel

• Bottom Panel with Product Label

Top Panel

The LEDs of the wireless access point are described in the following figure and table:

Figure 1. Top panel with LEDs

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 151 152

Pas de commentaire

Netgear WNDAP380Rv2 Manuel d'utilisateur Page 11