Netgear WNDAP350 Guide de l'utilisateur télécharger pdf (Page 70)

ProSafe Dual Band Wireless N Access Point WNDAP350 Reference Manual

3-2 Management

v2.0, April 2013

To set up an SNMP management interface:

1. Under the Maintenance tab, select Remote Management, and then select SNMP from the

left sidebar. The SNMP screen displays, as shown in Figure 3-1 below:

2. Enter the following information in the SNMP fields:

•SNMP: Enable SNMP to allow the SNMP network management software, such as HP

OpenView, to manage the wireless access point via SNMPv1/v2 protocol.

• Read-Only Community Name: The community string to allow the SNMP manager to

read the wireless access point's MIB objects. The default is Public.

• Read-Write Community Name: The community string to allow the SNMP manager to

read and write the wireless access point's MIB objects. The default is Private.

• Trap Community Name: The community string to allow the SNMP manager to send

traps. The default is trap.

• IP address to Receive Traps: The IP address of the SNMP manager to receive traps sent

from the wireless access point.

• Trap Port: The port number on which the SNMP Manager will receive traps. The default

is 162/UDP.

Figure 3-1 Configure SNMP settings

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 137 138

Pas de commentaire

Netgear WNDAP350 Guide de l'utilisateur Page 70