Netgear WNDAP350 Guide de l'utilisateur télécharger pdf (Page 28)

ProSafe Dual Band Wireless N Access Point WNDAP350 Reference Manual

2-6 Basic Installation and Configuration

v2.0, April 2013

4. Access Point Name: Enter the access point name of the WNDAP350.

This unique name is the access point NetBIOS name. The default Access Point Name is

located on the bottom label of WNDAP350. The default is netgearxxxxxx, where xxxxxx

represents the last 6 digits of the WNDAP350 MAC address. You may modify the default

name with a unique name up to 15 characters long.

5. From the Country/Region pull-down menu, select the region where the WNDAP350 can be

used (the default Country/Region is the United States).

6. Spanning Tree Protocol. Enable or disable spanning tree protocol. Spanning tree protocol

enables network traffic optimization in settings with multiple WNDAP350 wirelss access

points. The default is Disable.

7. 802.1Q VLAN. This section allows each Security Profile to be associated with the default

VLAN for WNDAP350. (Useful primarily if the hubs/switches on your LAN support the

VLAN 802.1Q standard.)

Figure 2-3 Access Point Name and Country / Region

Note: If your country or region is not listed, please check with Netgear Support.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 137 138

Pas de commentaire

Netgear WNDAP350 Guide de l'utilisateur Page 28