Netgear WG302v1 Manuel d'utilisateur Page 81

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 98
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 80
NETGEAR ProSafe 802.11g Wireless Access Point WG302 Reference Manual
Advanced Configuration 4-9
v4.0, April 2006
Click Apply.
Configuring Wireless Repeater Mode
To configure wireless repeater mode as shown in Figure 4-7:
1. Under Advanced on the maim menu, select Advanced Access Point Settings. The Advanced
Access Point Settings screen (shown in Figure 4-4) will display.
2. Configure the Operating Mode of the ProSafe 802.11gs.
WG302 (AP1) on LAN Segment 1 in Repeater mode with the Remote MAC Address of
AP2.
Configure WG302 (AP2) in Repeater mode with MAC addresses of AP1 and AP3.
Configure the WG302 (AP3) in Repeater mode with the Remote MAC Address of AP2.
3. Verify the following parameters for all access points:
Verify that the LAN network configuration the ProSafe 802.11gs are configured to operate
in the same LAN network address range as the LAN devices
Note: You can extend this multi-point bridging by adding additional WG302s configured
in Point-to-Point mode for each additional LAN segment. Furthermore, you can
extend the range of the wireless network with NETGEAR wireless antenna
accessories.
Figure 4-7.
AP in Repeater Mode
with client associations
LAN
Segment 1
192.168.0.1
Router
AP in Repeater Mode
with client associations
AP in Repeater Mode
with client associations
AP1
ETHERNET
RESET
5-12VDC
AP3
ETHERNET
RESET
5-12VDC
AP2
ETHERNET
RESET
5-12VDC
Wireless PC
Associated with AP3
Wireless PC
Associated with AP2
Wireless PC
Associated with AP1
Vue de la page 80
1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 97 98

Commentaires sur ces manuels

Pas de commentaire