Netgear XSM7224S Manuel d'utilisateur Page 49

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 579
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 48
ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
Switching Commands 3-8
v1.0, November 2010
show port
This command displays port information.
show port protocol
This command displays the Protocol-Based VLAN information for either the entire system, or for
the indicated group.
Format show port {<unit/slot/port> | all}
Mode Privileged EXEC
Term Definition
Interface Valid slot and port number separated by forward slashes.
Type If not blank, this field indicates that this port is a special type of port. The possible
values are:
Mirror - this port is a monitoring port. For more information, see “Port Mirroring” on
page 3-115.
PC Mbr- this port is a member of a port-channel (LAG).
Probe - this port is a probe port.
Admin Mode The Port control administration state. The port must be enabled in order for it to be
allowed into the network. - May be enabled or disabled. The factory default is enabled.
Physical Mode The desired port speed and duplex mode. If auto-negotiation support is selected, then
the duplex mode and speed is set from the auto-negotiation process. Note that the
maximum capability of the port (full duplex -100M) is advertised. Otherwise, this object
determines the port's duplex mode and transmission rate. The factory default is Auto.
Physical Status The port speed and duplex mode.
Link Status The Link is up or down.
Link Trap This object determines whether or not to send a trap when link status changes. The
factory default is enabled.
LACP Mode LACP is enabled or disabled on this port.
Format show port protocol {<groupid> | all}
Mode Privileged EXEC
Vue de la page 48
1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 578 579

Commentaires sur ces manuels

Pas de commentaire