Netgear XSM7224S Manuel d'utilisateur Page 300

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 579
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 299
ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
Quality of Service (QoS) Commands 5-26
v1.0, November 2010
The service commands attach a defined policy to a directional interface. You can assign only one
policy at any one time to an interface in the inbound direction. DiffServ is not used in the outbound
direction.
This set of commands consists of service addition/removal.
The CLI command root is service-policy.
service-policy
This command attaches a policy to an interface in the inbound direction. The <policyname>
parameter is the name of an existing DiffServ policy. This command causes a service to create a
reference to the policy.
Note: This command effectively enables DiffServ on an interface in the inbound
direction. There is no separate interface administrative 'mode' command for
DiffServ.
Note: This command fails if any attributes within the policy definition exceed the
capabilities of the interface. Once a policy is successfully attached to an interface,
any attempt to change the policy definition, that would result in a violation of the
interface capabilities, causes the policy change attempt to fail.
Format service-policy in <policymapname>
Modes Global Config
Interface Config
Note: Each interface can have one policy attached.
Vue de la page 299
1 2 ... 295 296 297 298 299 300 301 302 303 304 305 ... 578 579

Commentaires sur ces manuels

Pas de commentaire