Netgear XSM7224S Manuel d'utilisateur Page 196

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 579
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 195
ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
Switching Commands 3-155
v1.0, November 2010
When the optional argument <vlanid> is not used, the command displays the following
information.
When you specify a value for <vlanid>, the following additional information appears.
When the optional argument detail is used, the command shows the global information and the
information for all Querier-enabled VLANs.
Field Description
Admin Mode Indicates whether or not IGMP Snooping Querier is active on the switch.
Admin Version The version of IGMP that will be used while sending out the queries.
Querier
Address
The IP Address which will be used in the IPv4 header while sending out IGMP queries. It
can be configured using the appropriate command.
Query Interval The amount of time in seconds that a Snooping Querier waits before sending out the
periodic general query.
Querier Timeout The amount of time to wait in the Non-Querier operational state before moving to a
Querier state.
Field Description
VLAN Admin
Mode
Indicates whether iGMP Snooping Querier is active on the VLAN.
VLAN
Operational
State
Indicates whether IGMP Snooping Querier is in “Querier” or “Non-Querier” state. When
the switch is in Querier state, it will send out periodic general queries. When in Non-
Querier state, it will wait for moving to Querier state and does not send out any queries.
VLAN
Operational
Max Response
Time
Indicates the time to wait before removing a Leave from a host upon receiving a Leave
request. This value is calculated dynamically from the Queries received from the
network. If the Snooping Switch is in Querier state, then it is equal to the configured
value.
Querier Election
Participation
Indicates whether the IGMP Snooping Querier participates in querier election if it
discovers the presence of a querier in the VLAN.
Querier VLAN
Address
The IP address will be used in the IPv4 header while sending out IGMP queries on this
VLAN. It can be configured using the appropriate command.
Operational
Version
The version of IPv4 will be used while sending out IGMP queries on this VLAN.
Last Querier
Address
Indicates the IP address of the most recent Querier from which a Query was received.
Last Querier
Version
Indicates the IGMP version of the most recent Querier from which a Query was received
on this VLAN.
Vue de la page 195
1 2 ... 191 192 193 194 195 196 197 198 199 200 201 ... 578 579

Commentaires sur ces manuels

Pas de commentaire