Netgear WNDAP330 Guide de l'utilisateur Page 94

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 142
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 93
ProSafe Dual Band Wireless Access Point WNDAP330 Reference Manual
4-2 Advanced Configuration
v1.0, May 2008
.
3. Configure the following TCP/IP configurations for using the WNDAP330 as a DHCP Server
for wireless clients.
DHCP Server: By default, the Dynamic Host Configuration Protocol (DHCP) server is
disabled. If you have a DHCP server on your LAN and you enable DHCP, the wireless
access point will get its IP address, subnet mask and default gateway settings
automatically from the DHCP server on your network when you connect the WNDAP330
to your LAN.
Starting IP Address: Enter the starting IP address that can be assigned from the DHCP
server on this Access Point.
Ending IP Address: Enter the Ending IP address that can be assigned from the DHCP
server on this Access Point
Subnet Mask: The Access Point will assign the specified subnet mask to the connected
wireless stations.
Figure 4-1
Vue de la page 93
1 2 ... 89 90 91 92 93 94 95 96 97 98 99 ... 141 142

Commentaires sur ces manuels

Pas de commentaire