Netgear WNDAP330 Guide de l'utilisateur Page 36

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 142
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 35
ProSafe Dual Band Wireless Access Point WNDAP330 Reference Manual
2-10 Basic Installation and Configuration
v1.0, May 2008
Configuring Wireless Access
To configure your wireless settings for 11b/g/n and 11a/n:
1. From the main menu under Configuration, select Wireless. The Wireless Settings screen will
display, as shown in
Figure 2-7.
2. Enter the wireless settings for your area. See the online help or “Wireless Settings” on
page 2-14.
3. Click Apply to save your settings.
When you have completed the setup steps, you can deploy the WNDAP330 in your network. If
needed, you can now reconfigure the computer you used in step 1 (from the Static IP) back to its
original TCP/IP settings.
Deploying the WNDAP330 Wireless Access Point
To deploy the WNDAP330 Wireless Access Point:
1. Disconnect the WNDAP330 and position it where it will be deployed. The best location is
elevated, such as wall mounted or on the top of a cubicle, at the center of your wireless
coverage area, and within line of sight of all the mobile devices.
2. Lift the antenna on either side so that they are vertical.
Figure 2-7
Note: Refer to the antenna positioning and wireless mode configuration information
in the
Advanced Configuration chapter of the Reference Manual.
Vue de la page 35
1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 141 142

Commentaires sur ces manuels

Pas de commentaire