Netgear DG834 Instructions d'exploitation télécharger pdf (Page 27)

Reference Manual for the Model DG834 ADSL Firewall Router

Connecting the Router to the Internet 3-5

Connecting the DG834 to Your LAN

This section provides instructions for connecting the DG834 ADSL router.

Note: The Resource CD included with your router contains an animated Installation Assistant to

help you through this procedure.

How to Connect the Router

There are four steps to connecting your firewall:

1. Connect the router to your ADSL line.

2. Connect the router to the computers on your network.

3. Log in to the router.

4. Connect to the Internet.

Follow the steps below to connect your router to your network. Before you begin, locate the ADSL

configuration information from your Internet Service Provider (ISP).

1. CONNECT THE DG834 TO THE ADSL LINE.

a. You need to install a filter on every telephone or device that shares the same phone

number as your ADSL router. Select the filter that came with your router.

Figure 3-3: ADSL microfilters

Note: If you purchased the DG834 in a country where the filter is not included, you must

acquire one.

b. Two-Line Filter Example. Insert the two-line filter into the phone outlet and connect the

phone to the phone line connector (A):

Phone

DSL

Line

One-Line Filter

Two-Line Filter

Splitter

With Splitter

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 141 142

Pas de commentaire

Netgear DG834 Instructions d'exploitation Page 27