Netgear WNAP210 Manuel d'utilisateur télécharger pdf (Page 40)

Monitoring

ProSafe Wireless-N Access Point WNAP210

System Information

The System screen you access from the Monitoring tab provides a summary of the current

access point configuration settings, including current IP settings and current wireless

settings. This information is read-only, so any changes have to be made on other screens.

To access the System screen, select Monitoring > System.

This screen shows the following information:

• Access Point Name. The NetBIOS name. The default name can be changed.

• MAC Address. The MAC address of the access point’s Ethernet port.

• Country/Region. The domain or region for which the access point is licensed for use. It

might not be legal to operate this access point in a region other than one of those

identified in this field.

• Firmware Version. The version of the firmware currently installed.

• Current Time. The time setting for the access point.

• IP Address. The IP address of the access point.

• Subnet Mask. The subnet mask for the access point.

• Default Gateway. The default gateway for the access point communication.

• DHCP Client. Enabled indicates that the current IP address was obtained from a DHCP

server on your network. Disabled indicated a static IP configuration.

• Access Point Mode. The operating mode of the access point: Access Point or

Point-to-point • Channel/Frequency. The channel the wireless port is using.

• Rogue AP Detection. Shows whether the rogue AP detection feature is enabled.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 81 82

Pas de commentaire

Netgear WNAP210 Manuel d'utilisateur Page 40