Netgear ANT24BNA Fiche technique télécharger pdf (Page 2)

Introduction

This section introduces the NETGEAR ANT24BNA 500 mW Bi-directional Booster and the

NETGEAR ANT24BDC 6 VDC, 1.5A Power Injector and related components.

The 500-milliwatt bi-directional power booster for the NETGEAR ME103 802.11b ProSafe

Wireless Access Point increases the transmission signal from an average 50 mW to 500 mW

and amplifies the signal by 10 dB (10 times) in receive mode. Use this when you want to

maintain a single access point device to cover a larger area.

The ANT24BDC enables locating an antenna and a NETGEAR ANT24BNA booster more

than 30 feet away from the wireless unit in a remote area where electrical power is not available.

DC power is supplied to the booster through the antenna cable by means of the power injector.

This eliminates the need to install extra wires. Moreover, unlike power over Ethernet devices,

this configuration never needs to be reset.

The booster and power injector are part of a wireless system, including the access point, cables

and antennas. According to FCC regulations, the booster can only be used with the wireless

access point that is provided with it. Check http://www.NETGEAR.com/go/antennas_fcc for a

list of approved devices.

500 mW Booster Package Contents

The package should contain

• NETGEAR 500mW Bi-directional Booster for 802.11b ANT24BNA

• NETGEAR PWR-10015-01 DC power adapter

• Ceiling/wall mount bracket and hardware

• Installation guide

• Warranty card

• Support information card

Installation Guide,

Warranty card and

Support information card

500 mW Bi-directional booster

ANT24BNA

Wall and ceiling

mount bracket

and hardware

Power adapter

1 2 3 4 5 6 7 8 9

Pas de commentaire

Netgear ANT24BNA Fiche technique Page 2