Netgear GS728TP Manuel d'utilisateur télécharger pdf (Page 453)

100

101

Managing Device Security

453

ProSafe M5300 Switch

IP Binding Configuration

When an ACL is bound to an interface, all the rules that have been defined are applied to the

selected interface. Use the IP Binding Configuration page to assign ACL lists to ACL

Priorities and Interfaces.

To display the IP Binding Configuration page, click Security

 ACL> Advanced  IP Binding

Configuration.

To configure IP ACL interface bindings:

1. Select an existing IP ACL from the ACL ID menu.

The packet filtering direction for ACL is Inbound, which means the IP ACL rules are

applied to traffic entering the port.

2. Specify an optional sequence number to indicate the order of this access list relative to other

access lists already assigned to this interface and direction.

A low number indicates high precedence order. If a sequence number is already in use

for this interface and direction, the specified access list replaces the currently attached

access list using that sequence number. If the sequence number is not specified by the

user, a sequence number that is one greater than the highest sequence number currently

in use for this interface and direction will be used. The valid range is 1–4294967295.

3. Click the appropriate orange bar to expose the available ports or LAGs. The Port Selection

Table specifies list of all available valid interfaces for ACL mapping. All non-routing physical

interfaces and interfaces participating in LAGs are listed.

• To add the selected ACL to a port or LAG, click the box directly below the port or LAG

number so that an X appears in the box.

• To remove the selected ACL from a port or LAG, click the box directly below the port

or LAG number to clear the selection. An X in the box indicates that the ACL is

applied to the interface.

4. Click CANCEL to cancel the configuration on the screen and reset the data on the screen to

the latest value of the switch.

5. Click APPLY to save any changes to the running configuration.

1 2 ... 448 449 450 451 452 453 454 455 456 457 458 ... 529 530

Commentaires sur ces manuels

Pas de commentaire

Netgear GS728TP Manuel d'utilisateur Page 453

Commentaires sur ces manuels

Produits connexes et manuels pour Logiciel Netgear GS728TP