Netgear GS728TP Manuel d'utilisateur Page 305

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 530
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 304
Routing
305
ProSafe M5300 Switch
SSM Configuration
The settings on this page are valid for PIM-SM and do not apply if the PIM mode is PIM-DM.
While PIM-SM employs a specially-configured RP router that serves as a meeting junction for
multicast senders and listeners, Protocol-Independent Multicast Source Specific Multicast
(PIM-SSM) does not use an RP. It supports only source route deliver trees. It is used
between routers so that they can track which multicast packets to forward to each other and
to their directly-connected LANs. The SSM service model can be implemented with a strict
subset of the PIM-SM protocol mechanisms. Both regular IP Multicast and SSM semantics
can coexist on a single router and both can be implemented using the PIM-SM protocol. A
range of multicast addresses, currently 232.0.0.0/8 in IPv4, is reserved for SSM.
To display the SSM Configuration page, click Routing Multicast PIM SSM
Configuration.
To configure PIM SSM:
1. Use SSM Group Address to enter the source-specific multicast group ip-address.
2. Use SSM Group Mask to enter the source-specific multicast group ip-address mask.
3. Click ADD to add a new source-specific group.
4. Click DELETE to delete an existing source-specific group.
Vue de la page 304
1 2 ... 300 301 302 303 304 305 306 307 308 309 310 ... 529 530

Commentaires sur ces manuels

Pas de commentaire