Netgear WNR2000v3 Manuel d'utilisateur télécharger pdf (Page 28)

Configuring Your Wireless Network 24

You can use WPS in one of two ways:

• If the router’s SSID and security option have already been set (see “Setting Your SSID and

Wireless Security” on page 22), a wireless device can be connected to your wireless network

quickly and simply by using WPS. In this case, the existing wireless settings are transmitted to

the WPS-capable device.

• If the router’s wireless options have not yet been configured and security has not been enabled

(the router is in its default state), WPS automatically configures the SSID and wireless security

settings for the router and then transmits these settings to the wireless device, such as a

wireless PC.

The first method is explained here. For more information on the second method, see the User

Manual.

If your network consists of WPS capable devices and non-WPS capable devices, NETGEAR

suggests that you set up your wireless network and security settings first using the manual or

traditional method (see “Setting Your SSID and Wireless Security” on page 22), and use WPS

only for adding additional WPS capable devices.

To add a wireless device using WPS:

1. Press the WPS button on your router. The router will start transmitting its wireless settings.

You have 2 minutes to press a corresponding WPS button on your wireless device.

2. On your wireless device, either:

• Press an external WPS button on the outside of the device or,

• Open the WPS utility on the device and follow the instructions to connect using WPS.

The WPS LED on the router will continue to blink during the 2-minute window. When the

connection has been made, the WPS LED will turn solid green. If no connection is made, when the

LED stops blinking it will turn off..

Then, to access the Internet, launch a browser (such as Microsoft Internet Explorer or Mozilla

Firefox) from the device. You should see the wireless router’s Internet LED blink, indicating

communication with the ISP.

The only security setting that doesn’t work with WPS is WEP with shared-key

authentication.

If security was already configured using the traditional method, the WPS LED will

remain on.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 41 42

Pas de commentaire

Netgear WNR2000v3 Manuel d'utilisateur Page 28