Netgear WNR2000v3 Manuel d'utilisateur télécharger pdf (Page 17)

Manually Installing Your Router 13

Connecting Your Wireless Router

Before you install your wireless router, make sure that the Internet Protocol (TCP/IP) Property

settings on your computer are set to “automatically obtain an IP address” using DHCP and “Obtain

DNS server address automatically.” You can check these settings by looking at the TCP/IP

Properties of your Internal Network Connections, which are accessible through the Control Panel

of your computer. If you are unsure about this, refer to the documentation for your computer or see

the link to TCP/IP Addressing in “Related Documents” on page 37.

If you are replacing an existing router, disconnect it completely from your network and set it aside

before starting to install your new router. Then, skip to step 5 in the following procedure

To connect the wireless router, the computer, and the modem:

1. Turn off your computer.

2. Turn off and unplug the cable or DSL broadband modem.

3. Locate the cable (A) that connects your computer to the modem.

4. Disconnect the cable at the modem end only (B). You will connect it to the router later.

NETGEAR does not recommend or support adding a NETGEAR router behind

another router, or replacing a gateway with a NETGEAR router.

Figure 7

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 41 42

Pas de commentaire

Netgear WNR2000v3 Manuel d'utilisateur Page 17