Netgear Modem DGN2200V3 Manuel d'utilisateur Page 101
- Page / 120
- Table des matières
- DEPANNAGE
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
Troubleshooting
101
N300 Wireless ADSL2+ Modem Router DGN2200v3
Troubleshooting with the LEDs
When you turn the power on, the power, LAN, and DSL LEDs should light as described here.
If they do not, refer to the sections that follow for help.
1. W
hen power is first applied, the Power LED lights.
2. Af
ter approximately 10 seconds, the LAN and DSL LEDs light as follows:
a. T
he LAN port LEDs light for any local ports that are connected.
b. T
he DSL link LED lights to indicate that there is a link to the connected device.
c. I
f a LAN port is connected to a 100 Mbps device, verify that the LAN port’s LED is
green. Note that if the LAN port is 10 Mbps, the LED is amber.
Power LAN Ports (1–4) USB DSL Wireless WPSInternet
Figure 12. Front panel LEDs
Power LED Is Off
If the Power and other LEDs are off when your modem router is turned on:
• Check that
the power cord is correctly connected to your modem router and the power
supply adapter is correctly connected to a functioning power outlet.
• Check that
you are using the 12 V DC power adapter supplied by NETGEAR for this
product.
If the error persists, you could have a hardware problem and should contact NETGEAR
T
echnical Support.
Power LED Is Red
When the modem router is turned on, it performs a power-on self-test during which time the
Power LED turns red. If the Power LED does not turn green within a minute or so or if it turns
red at any other time during normal operation there is a fault within the modem router.
- N300 Wireless ADSL2+ 1
- Modem Router DGN2200v3 1
- Technical Support 2
- Trademarks 2
- Statement of Conditions 2
- Contents 3
- Chapter 4 Security Settings 4
- Chapter 6 USB Storage 5
- Chapter 7 Advanced Settings 5
- Chapter 8 Troubleshooting 5
- Unpack Your Modem Router 8
- Hardware Features 8
- Back Panel 9
- Front Panel 9
- Table 1. Front Panel LEDs 10
- Modem Router Stand 11
- Position Your Modem Router 12
- ADSL Microfilters 12
- One-Line ADSL Microfilter 13
- Two-Line ADSL Microfilter 13
- Cable Your Modem Router 14
- Hardware Setup 15
- Verify the Cabling 16
- Modem Router Setup 17
- Gather ISP Information 18
- NETGEAR Genie Setup 19
- Log In to the Modem Router 20
- Upgrade Modem Router Firmware 21
- Modem Router Interface 21
- Setup Wizard 22
- Manual Setup (Basic Settings) 23
- ADSL Settings 26
- Log Out Manually 28
- Types of Logins 28
- Wireless Settings 29
- Preset Security 30
- Security Basics 30
- Disable SSID Broadcast 31
- Wireless Security Options 31
- Manual Method 32
- Wireless Settings Screen 33
- Wireless Network 35
- Security Options Settings 35
- To set up WEP security: 36
- Wireless Guest Networks 37
- Security Settings 39
- Activation and Administration 41
- Dropped Packets 41
- Set Up Firewall Rules 43
- Add a Custom Service 47
- Set Up Port Triggering 49
- Set the Time Zone 52
- Schedule Services 53
- Network Maintenance 56
- Automatic Firmware Check 57
- View Router Status 60
- Internet Port Settings 61
- LAN Port (Local Ports) 61
- Wireless Port 61
- Show Statistics 62
- View Attached Devices 63
- Run Diagnostic Utilities 64
- USB Storage 65
- USB Drive Requirements 66
- ReadySHARE Access 66
- Sharing Photos 67
- USB Storage Basic Settings 68
- Edit a Network Folder 70
- Access Method 71
- Available Network Folders 72
- Safely Remove USB Drive 73
- Media Server Settings 73
- Advanced Settings 77
- WAN Setup 78
- Default DMZ Server 79
- Dynamic DNS 80
- LAN Setup 81
- LAN Setup Screen Settings 82
- IP Address Reservation 82
- Quality of Service (QoS) 83
- Advanced Wireless Settings 85
- WPS Settings 86
- Wireless Card Access List 86
- Remote Management 87
- Static Routes 88
- To add a static route: 89
- Universal Plug and Play 90
- To set up UPnP: 91
- Traffic Meter 92
- 192.168.0.1 95
- Internet 95
- Change the Device Mode 99
- Troubleshooting 100
- Troubleshooting with the LEDs 101
- LAN LED Is Off 102
- ADSL Link LED Is Green 103
- ADSL Link LED Is Off 103
- Internet LED Is Red 104
- TCP/IP Network Not Responding 105
- Changes Not Saved 107
- Incorrect Date or Time 107
- Supplemental Information 108
- Factory Settings 109
- Specifications 111
- Notification of Compliance 112
- FCC Information to User 114
- FCC Declaration of Conformity 114
- FCC Caution 114
- Interference Reduction Table 116
Produits connexes et manuels pour Routeurs Netgear Modem DGN2200V3
Routeurs Netgear RH348 Manuel d'utilisateur
(142 pages)
(142 pages)
(64 pages)
Routeurs Netgear TA612V Manuel d'utilisateur
(126 pages)
(126 pages)
Routeurs Netgear 762S Guide de l'utilisateur
(74 pages)
(74 pages)
Routeurs Netgear DC112A Guide de l'utilisateur
(156 pages)
(156 pages)
Routeurs Netgear NTGWGR614 Manuel d'utilisateur
(146 pages)
(146 pages)
Routeurs Netgear DG814 Manuel d'utilisateur
(16 pages)
(16 pages)
Routeurs Netgear WND930 Manuel d'utilisateur
(67 pages)
(67 pages)
Routeurs Netgear DGND3300 Manuel d'utilisateur
(118 pages)
(118 pages)
Routeurs Netgear DG814 DSL Manuel d'utilisateur
(112 pages)
(112 pages)
Routeurs Netgear WPN824 Manuel d'utilisateur
(174 pages)
(174 pages)
Routeurs Netgear WNR834B Manuel d'utilisateur
(128 pages)
(128 pages)
© 2020, manymanuals.fr. Tous droits réservés | 2.216 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels