Netgear PS100 Manuel d'utilisateur télécharger pdf (Page 12)

NetGear Print Server Manual

Rear Panel of PS111W

The rear panel of the Model PS111W Print Sever has a parallel port for printer. The Model PS111W

Print Sever has one 10/100BASE-T network port. The 10/100BASE-T port is an auto negotiation port

that operates in 100 Mbps and in half-duplex mode when connected to a Fast Ethernet network. The

diagnostic print and reset to factory default button can print the current print server setup including

IP address and wireless information by pressing and holding it two seconds. If press and hold the

button for ten seconds while powering from off to on, the print server will load the factory default

setting back into its flash memory.

The Rear Panel as illustrated below, it has a power adapter receptacle that accepts a 12 V 800mA DC

power adapter.

Figure 1-2 Rear Panel of the Model PS111W Print Sever

Key:

1 = Side panel wireless PC card slot

2 = PRINTER (parallel) port

3 = NETWORK port (10/100BASE-T connector)

4 = Diagnostic print and reset to factory default button

5 = Power adapter receptacle

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 141 142

Pas de commentaire

Netgear PS100 Manuel d'utilisateur Page 12