Netgear FS 750 Manuel d'utilisateur télécharger pdf (Page 46)

C-5cabling guidelines

Patch Panels and Cables

If you are using patch panels,make sure that they meet the 100BASE-TX requirements.

NETGEAR recommends Category 5 UTP cable for all patch cables and work area

cables to ensure that your UTP patch cable rating meets or exceeds the distribution

cable rating.

To wire patch panels, you need two Category 5 UTP cables with an RJ-45 plug at each

end, as shown in Figure C-3.

Figure C-3.Category 5 UTP Cable with Male RJ-45 Plug at Each End

Note: Flat “silver satin” telephone cable may have the same RJ-45 plug.

However, using telephone cable results in excessive collisions,causing the attached

port to be partitioned or disconnected from the network.

Using 1000BASE-T Gigabit Ethernet over Category 5 Cable

Overview

When using the new 1000BASE-T standard, the limitations of cable installations and

the steps necessary to ensure optimum performance must be considered.The most

important components in your cabling system are patch panel connections, twists of the

pairs at connector transition points,the jacket around the twisted-pair cable, bundling

of multiple pairs on horizontal runs and punch down blocks. All of these factors affect

the performance of 1000BASE-T technology if not correctly implemented.The follow-

ing sections are designed to act as a guide to correct cabling for 1000BASE-T.

87654321

2 1

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 52

Pas de commentaire

Netgear FS 750 Manuel d'utilisateur Page 46