Netgear FS 750 Manuel d'utilisateur télécharger pdf (Page 27)

4-3installation

Installing the Switch

You can install the NETGEAR FS726 and FS750 Switches on a flat surface or in a

standard 19-inch rack.

Installing the Switch on a Flat Surface

1. The switch ships with four self-adhesive rubber footpads. Affix one rubber footpad

on each of the four concave spaces on the bottom of the switch.The rubber

footpads cushion the switch against shock/vibrations.

Installing the Switch in a Rack

To install the FS726 or FS750 Switch in a rack,use the following procedure (and refer

to Figure 4-1).To perform this procedure,you need the 19-inch rack-mount kit supplied

with your switch.

1. Attach the supplied mounting brackets to the side of the switch.

2. Insert the screws provided in the rack-mount kit through each bracket and into the

bracket mounting holes in the switch.

3. Tighten the screws with a #1 Phillips screwdriver to secure each bracket.

4. Align the mounting holes in the brackets with the holes in the rack, and insert two

pan-head screws with nylon washers through each bracket and into the rack.

5. Tighten the screws with a #2 Phillips screwdriver to secure the switch in the rack.

6. Proceed to "Connecting Devices to the Switch."

Figure 4-1.Attaching Mounting Brackets

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 51 52

Pas de commentaire

Netgear FS 750 Manuel d'utilisateur Page 27