Netgear FVG318 Manuel d'utilisateur Page 126

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 176
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 125
ProSafe 802.11g Wireless VPN Firewall FVG318 Reference Manual
7-2 Maintenance
v1.0, September 2007
This screen shows the following parameters:
Table 7-1. FVG318 Status fields
Field Description
System Name The System Name assigned to the firewall.
Firmware Version The firewall firmware version.
Wireless Configuration The wireless settings of the router
SSID: The name of your wireless network. The default is NETGEAR.
Mode
Security Settings Shows what security has been associated with the wireless configuration. The
default is none
Region Shows the region is which the wireless gateway is operating
Channel Indicates the operating channel of the wireless radio.
AP MAC Address The MAC address of the wireless access point.
WAN Port These parameters apply to the Internet (WAN) port of the firewall.
WAN State Indicates if the WAN port is up or down.
NAT Indicates if the router is in NAT mode (enabled) or in routing mode (disabled).
DHCP The protocol on the WAN port used to obtain the WAN IP address. This field
can show DHCP Client, Fixed IP, PPPoE, BPA or PPTP. For example, if set to
Client, the firewall is configured to obtain an IP address dynamically from the
ISP.
Connection State Indicates if the WAN port is connected or not.
IP Address The IP address used by the Internet (WAN) port of the firewall. If no address is
shown, the firewall cannot connect to the Internet.
IP Subnet Mask The IP Subnet Mask being used by the Internet (WAN) port of the firewall.
Gateway Gateway address of the WAN port.
Primary DNS DNS server IP address of the WAN port.
Secondary DNS Secondary DNS server IP address of the WAN port (if not assigned, it will be
the same as the primary DNS server).
DHCP The protocol on the WAN port used to obtain the WAN IP address. This field
can show DHCP Client, Fixed IP, PPPoE, BPA or PPTP. For example, if set to
Client, the firewall is configured to obtain an IP address dynamically from the
ISP.
MAC Address The MAC address used by the Internet (WAN) port of the firewall.
LAN Port These parameters apply to the Local (WAN) port of the firewall.
MAC Address The MAC address used by the LAN port of the firewall.
Vue de la page 125
1 2 ... 121 122 123 124 125 126 127 128 129 130 131 ... 175 176

Commentaires sur ces manuels

Pas de commentaire