Netgear WG111v2 Guide de l'utilisateur télécharger pdf (Page 40)

User Manual for the NETGEAR 54 Mbps Wireless USB 2.0 Adapter WG111

4-6 Configuration

202-10026-01

5. Verify wireless connectivity between your peer devices.

Verify connectivity by using the Ping program:

a. On the Windows taskbar click the Start button, and then click Run.

Figure 4-3: Windows Run program dialog box

b. Assuming the target PC is configured with 192.168.0.1 as its IP address, type ping -t

192.168.0.1 and then click OK.

c. This will cause a continuous ping to be sent to the device with the 192.168.0.1 static IP

address. The ping response should change to “reply.”

Figure 4-4: Ping test results

At this point the connection is established.

You may need to reboot in certain Windows operating systems such as Windows 98SE.

Note: If you cannot connect, see Chapter 4, “Troubleshooting”. Also, for problems with

accessing network resources, Windows Client and File and Print Sharing software might not

be installed and configured properly on your computers. Please refer to “Preparing Your

Computers for TCP/IP Networking” on page C-1.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 93 94

Pas de commentaire

Netgear WG111v2 Guide de l'utilisateur Page 40