Netgear WNAP320 Guide de l'utilisateur télécharger pdf (Page 63)

Chapter 4. Management | 63

ProSafe Wireless-N Access Point WNAP320 Reference Manual

Figure 36.

Use the Reset Button to Restore Factory Default Settings

To restore the factory default settings when you do not know the login user name, login

password, or IP address, you must use the Reset button on the rear panel of the wireless

access point (see Figure 2 on

page 12).

To restore the factory default settings using the Reset button:

1. Using a sharp obje

ct, press and hold the Reset button for about 5 seconds (until the Test

LED blinks rapidly) to reset the wireless access point to factory defaults settings.

Note: Pressing the Reset button for a shorter period of time simply causes

the wireless access point to reboot.

2. Release the Reset button.

During the restoration process, the wireless a

ccess point automatically restarts. The

restoration process typically takes about 1 minute. When the Test LED turns off, wait a

few more seconds before doing anything with the wireless access point.

Reboot the Wireless Access Point without Restoring the

Default Configuration

If you do not have physical access to the wireless access point to switch it off and on again,

you can use the software to reboot the wireless access point.

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 125 126

Pas de commentaire

Netgear WNAP320 Guide de l'utilisateur Page 63