Netgear 802.11g Manuel d'utilisateur télécharger pdf (Page 8)

5. Connect the provided Ethernet cable between the WGE101 Wireless Bridge and the

switch (or hub).

6. Connect each gaming console or other Ethernet-enabled device to the switch (or hub)

using an Ethernet cable.

7. Connect the switch’s (or hub’s) power adapter and plug that power adapter in to a power

outlet.

8. Connect the bridge’s power adapter and plug the power adapter in to a power outlet.

The Power and Wireless LAN lights should light up.

9. After the Wireless LAN light lights up, turn on any gaming console(s).

10. After turning on any gaming consoles, turn on any other Ethernet-enabled device(s).

If the bridge, switch, and the Ethernet-enabled devices are successfully connected, the

Network light will light up. This light flashes when there is network activity.

Note: If your setup works with the default settings, you don’t need to configure the bridge

unless you need to change the Country/Region setting from the default setting (United States)

or you need to assign a unique IP address to subsequent WGE101 bridges. See page 12 for

information on configuring the bridge.

Cable

or DSL

modem

Gaming console or other

Ethernet-enabled device

WGE101 54 Mbps

Wireless Ethernet Bridge

WGR614 54 Mpbs

Wireless Router

Fast Ethernet

Switch FS605

Ethernet-enabled

computer

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 25 26

Pas de commentaire

Netgear 802.11g Manuel d'utilisateur Page 8