Netgear ME103 Manuel d'utilisateur télécharger pdf (Page 28)

Reference Manual for the ME103 802.11b ProSafe Wireless Access Point

3-7 Basic Installation and Configuration

August 2003

Figure 3-3: Connecting the Ethernet cable to a router, hub, or switch

Connect an Ethernet cable from your ME103 Access Point to a LAN port (B) on your

router, switch, or hub.

Note: By default, ME103 is set to be a DHCP client. If your network uses static IP

addresses, you will need to change this setting.

d. Connect the power adapter to the wireless access point and plug the power adapter in to a

power outlet. The PWR, LAN, and Wireless LAN lights and should light up.

e. Connect the power adapter to the wireless access point and plug the power adapter in to a

power outlet. The PWR, LAN, and Wireless LAN lights and should light up.

4VERIFY WIRELESS CONNECTIVITY

Using a computer with an 802.11b or 802.11g wireless adapter with the correct wireless

settings needed to connect to the ME103 (SSID, WEP, MAC ACL, 802.1x, etc.), verify

connectivity by using a browser such as Netscape or Internet Explorer to browse the Internet,

or check for file and printer access on your network.

Note: If you are unable to connect, see Chapter 6, “Troubleshooting.”

LOC A L

10/100M

876543221INTERN ET

12VDCO.5A

Router, Switch, or Hub

Broadband modem

ME103 802.11b

ProSafe Wir eless

Access Point

ETHERNET

RESET

5-12V DC

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 117 118

Pas de commentaire

Netgear ME103 Manuel d'utilisateur Page 28