Netgear WN802T Manuel d'utilisateur Page 59

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 78
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 58
RangeMax NEXT Wireless-N Access Point WN802T Reference Manual
Advanced Wireless Bridging 5-3
v1.0, August 2007
The following figure illustrates a multi-point bridge setup over three LAN segments.
To configure wireless access points in a multi-point configuration:
1. Set the Operating Mode of the three RangeMax NEXTs as follows:
Configure AP2 on LAN Segment 1 in Point-to-Point Bridge Mode. Enable Wireless Client
Association and add the Remote MAC Address of AP1 on LAN Segment 2.
Because it is in the central location, configure AP1 on LAN Segment 2 in Multi-Point
Bridging mode. Enable Wireless Client Association and add the MAC addresses of the
adjacent Point-to-Point APs (AP2 and AP3).
Configure AP3 on LAN 3 in Point-to-Point Bridge mode. Enable Wireless Client
Association and add the Remote MAC Address of AP1 on LAN Segment 2.
2. Verify the following parameters for all three wireless access points:
That the LAN network configuration of each of the RangeMax NEXTs is configured to
operate in the same LAN network address range as the other LAN devices (routers, hubs
and switches).
That only one wireless access point is configured in Multi-Point Bridging mode, and that
all the others are in Point-to-Point Bridge mode.
That all APs are be on the same LAN. That is, all the wireless access point LAN IP
addresses are in the same network.
Figure 5-2
AP2
AP1
AP3
LAN
Segment 1
LAN
Segment 2
LAN
Segment 3
PCs
PCs
PCs
Router
Hub or Switch
Hub or Switch
Wireless PC Card
in a Notebook Computer
192.168.0.1
Internet
Point-to-Point
Bridge Mode
Point-to-Point
Bridge Mode
Multi-Point
Bridge Mode
Vue de la page 58
1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 77 78

Commentaires sur ces manuels

Pas de commentaire