Netgear WG602v2 Guide de l'utilisateur télécharger pdf (Page 35)

Reference Manual for the WG602 v2 54 Mbps Wireless Access Point

Basic Installation and Configuration 3-12

M-10181-03

• Channel/Frequency. This field identifies which operating frequency will be used. It should

not be necessary to change the wireless channel unless you notice interference problems or

setting up the WG602 v2 near another access point. See “Wireless Channels” on page B-2 for

more information on wireless channels.

– Access points use a fixed channel. You can select the channel used. This allows you to

choose a channel which provides the least interference and best performance. In the USA

and Canada, 11 channels are available.

– If using multiple access points, it is better if adjacent access points use different channels

to reduce interference. The recommended channel spacing between adjacent access points

is 5 channels (for example, use channels 1 and 6, or 6 and 11).

– In “Infrastructure” mode, wireless stations normally scan all channels, looking for an

access point. If more than one access point can be used, the one with the strongest signal is

used. This can only happen when the various access points are using the same SSID.

• Mode. The default is g and b. You can change the mode to g or b only.

•Data Rate. Shows the available transmit data rate of the wireless network. The possible data

rates supported are: 1 Mbps, 2 Mbps, 5.5 Mbps, 6 Mbps, 9 Mbps, 11 Mbps, 12 Mbps, 24

Mbps, 36 Mbps, 48 Mbps, 54 Mbps, and Best.The default is Best.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 121 122

Pas de commentaire

Netgear WG602v2 Guide de l'utilisateur Page 35