Netgear 802.11g Manuel d'utilisateur télécharger pdf (Page 68)

Reference Manual for the NETGEAR ProSafe Wireless Access Point 802.11g WG302

5-8 Advanced Configuration

September 2004

How to Configure Multi-Point Wireless Bridging

Figure 5-7: Multi-Point bridging

Configure the Operating Mode of the WG302 Access Points.

– WG302 (AP1) on LAN Segment 1 in Point-to-Point Bridge mode with the Remote MAC

Address of AP2.

– Because it is in the central location, configure WG302 (AP2) on LAN Segment 2 in

Point-to-Multi-Point Bridge mode. The MAC addresses of the adjacent APs are required

in AP2.

– Configure the WG302 (AP3) on LAN 3 in Point-to-Point Bridge mode with the Remote

MAC Address of AP2.

2. Verify the following parameters for all access points:

• Verify that the LAN network configuration the WG302 Access Points are configured to

operate in the same LAN network address range as the LAN devices

• Only one AP is configured in Point-to-Multi-Point Bridge mode, and all the others are in

Point-to-Point Bridge mode.

• All APs must be on the same LAN. That is, all the APs LAN IP address must be in the

same network.

• If using DHCP, all WG302 Access Points should be set to “Obtain an IP address

automatically (DHCP Client)” in the IP Address Source portion of the Basic IP Settings

menu.

'Master' AP in

Point-to-Multi-Point

Bridge Mode

LAN

Segment 1

192.168.0.1

Router

AP in

Point-to-Point

Bridge Mode

Hub or Switch

LAN

Segment 3

AP in

Point-to-Point

Bridge Mode

LAN

Segment 2

Hub or Switch

AP1

ETHERNET

RESET

5-12VDC

AP3

ETHERNET

RESET

5-12VDC

AP2

ETHERNET

RESET

5-12VDC

1 2 ... 63 64 65 66 67 68 69 70 71 72 73 ... 107 108

Commentaires sur ces manuels

Pas de commentaire

Netgear 802.11g Manuel d'utilisateur Page 68

Commentaires sur ces manuels

Produits connexes et manuels pour Points d'accès WLAN Netgear 802.11g