Netgear WG311 Manuel d'utilisateur télécharger pdf (Page 19)

Installation Guide for the NETGEAR 54 Mbps Wireless PCI Adapter WG311

Basic Setup 2-3

WG311 Default Wireless Configuration Settings

If this is a new wireless network installation, use the factory default settings to set up the network

and verify wireless connectivity. If this is an addition to an existing wireless network, you will

need to identify the wireless configuration and security parameters already defined.

Your NETGEAR 54 Mbps Wireless PCI Adapter WG311 factory default basic settings are:

• Network Name Service Set Identification (SSID): ANY — a special name which indicates the

first available network will be used

Note: In order for the WG311 Wireless PCI Adapter to communicate with a wireless access

point or wireless adapter, all devices must be configured with the same wireless network name

(SSID).

• Network Mode (Infrastructure or Ad-Hoc): Infrastructure

• Data security WEP encryption: Disabled

The section below provides instructions for setting up the NETGEAR 54 Mbps Wireless PCI

Adapter WG311 for basic wireless connectivity to an access point. The procedures provide

step-by-step installation instructions for Windows PCs. Use the procedure that corresponds to the

version of Windows you are using.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 74 75

Pas de commentaire

Netgear WG311 Manuel d'utilisateur Page 19