Netgear RP114 Manuel d'utilisateur télécharger pdf (Page 130)

Reference Guide for the Model RP114 Web Safe Router

11-6 Troubleshooting

If the path is not working, you see this message:

Request timed out

If the path is not functioning correctly, you could have one of the following problems:

• Wrong physical connections

— Make sure the LAN LNK/ACT LED is on. If the LNK/ACT LED is off, follow the

instructions in “LNK/ACT LEDs Not On”onpage 11-2.

— Check that the corresponding Link LEDs are on for your network interface card and

for the hub ports (if any) that are connected to your workstation and router.

• Wrong network configuration

— Verify that the Ethernet card driver software and TCP/IP software are both installed

and configured on your PC or workstation.

— Verify that the IP address for your router and your workstation are correct and that the

addresses are on the same subnet.

1 2 ... 125 126 127 128 129 130 131 132 133 134 135 ... 154 155

Pas de commentaire

Netgear RP114 Manuel d'utilisateur Page 130