Netgear 778S Guide de l'utilisateur télécharger pdf (Page 77)

UPnP (Universal Plug and Play)

UPnP provides simple and robust connectivity among consumer electronics, intelligent

appliances, and mobile devices from many different vendors. (For more information, see

upnp.org.)

Note: If UPnP is enabled, there are potential security risks.

Enabling UPnP

Before you can use UPnP, you must enable it.

1. Log in to the home page. (See Logging In as an Administrator.)

2. Click Settings > Router > Basic.

3. Next to UPnP, select On.

4. Click Submit.

DHCP

DHCP (Dynamic Host Control Protocol) automatically assigns an IP address to each device on

the network and manages other network configuration information for devices connected to your

network. You do not need to manually configure the IP address on each device that’s on your

network.

The assigned IP addresses are not permanent (as opposed to when using static IP).

Most ISPs (Internet Service Providers) use DHCP.

Normally, you should enable DHCP, in which case you must configure each device on the

network with one of the following:

● TCP/IP settings set to “Obtain an IP address automatically.”

● TCP/IP bound to the Ethernet connection with DHCP.

If DHCP is disabled, you must configure each device on the network with:

● Fixed (permanent/static) IP address.

● DNS server addresses (provided by Virgin Mobile).

Enabling DHCP

1. Log in to the home page. (See Logging In as an Administrator.)

2. Click Settings > Router > Basic.

3. Next to DHCP Server, select Enabled.

Device Settings 76

1 2 ... 72 73 74 75 76 77 78 79 80 81 82 ... 168 169

Pas de commentaire

Netgear 778S Guide de l'utilisateur Page 77