Netgear GS110TP Manuel d'utilisateur télécharger pdf (Page 18)

GS110TP Hardware Installation Guide

4-2 Installation

v1.0, March 2010

Step 2: Installing the Switch

The GS110TP Smart PoE Switch can be used on a flat surface or mounted on the wall.

Installing the Switch on a Flat Surface

The switch ships with four self-adhesive rubber footpads. Stick one rubber footpad on each of the

four concave spaces on the bottom of the switch. The rubber footpads cushion the switch against

shock/vibrations.

Wall Mounting the Switch

To mount the switch on a wall (optional), install the two provided screws in positions that

correspond to the slots on the bottom side of the GS110TP, then mount the switch.

Power source Provide a power adapter (included). Power specifications for the switch are shown in

Appendix A . Ensure the AC outlet is not controlled by a wall switch, which can

accidentally turn off power to the outlet and the switch.

Environmental • Temperature - Install the switch in a dry area, with ambient temperature between 0 and

50ºC (32 and 122ºF). Keep the switch away from heat sources such as direct sunlight,

warm air exhausts, hot-air vents, and heaters.

• Operating humidity - The installation location should have a maximum relative

humidity of 90%, non-condensing.

• Ventilation - Do not restrict airflow by covering or obstructing air inlets on the sides of

the switch. Keep at least 2 inches (5.08 centimeters) free on all sides for cooling. Be

sure there is adequate airflow in the room or wiring closet where the switch is installed.

• Operating conditions - Keep the switch at least 6 ft. (1.83 m) away from nearest

source of electromagnetic noise, such as a photocopy machine.

Table 4-1. Site Requirements (continued)

Characteristics Requirements

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 31 32

Pas de commentaire

Netgear GS110TP Manuel d'utilisateur Page 18