Netgear ETHERNET SWITCH SW108 Manuel d'utilisateur télécharger pdf (Page 16)

Installation Guide for the Model SW108 Ethernet Switch

2-4 Physical Description

Rear Panel

As illustrated in Figure 2-3, the rear panel has full-duplex (FDX), and half-duplex (HDX) toggle

switches, a ground clip, and a standard AC power receptacle.

Key:

1 = Ground clip

2 = FDX and HDX toggle switches to set the duplex mode of each 10 Mbps port

3 = AC power outlet

Figure 2-3. Rear panel of the Model SW108 switch

FDX and HDX Duplex Toggle Switches

Full-duplex mode is supported for all 10 Mbps ports and allows a port to transmit and receive data

at the same time. Full-duplex operation applies only to point-to-point access where the remote

device also supports full-duplex. In half-duplex mode, the port can either transmit or receive data

at any time, but not transmit or receive data concurrently.

As illustrated in Figure 2-3, one full-duplex (FDX) and half-duplex (HDX) toggle switch is

assigned to each 10 Mbps port on the switch to set the communication mode to either full-duplex

or half-duplex mode.

887EA

HDX-

FDX -

Force port to operate at Half Duplex mode

Force port to operate at Full Duplex and Half Duplex mode only

FDX

HDX

10 Mbps

– +

SW108.BK Page 4 Friday, June 27, 1997 10:48 AM

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 39 40

Pas de commentaire

Netgear ETHERNET SWITCH SW108 Manuel d'utilisateur Page 16