Netgear WNDAP330 Manuel d'utilisateur télécharger pdf

Version 1.0

Layer 2 / Layer 3 switches and multi-SSID multi-VLAN network with traffic

separation

This document describes the steps to undertake in configuring a Layer 2/Layer 3 switch (in this

document a FMS7382S with firmware 7.3.1.7) and a WNDAP330 to host a multi-SSID and multi-

VLAN network.

The solution will allow separating the Wireless traffic and Wired traffic of each of the VLANs

configured, from any other VLAN which will exist on the Wired or Wireless LAN.

The diagram below shows a typical scenario.

VLAN

LAYER2/LAYER3 SWITCH

VLAN1:

Management IP 192.168.0.254

Port: 1/0/1, 1/0/6, 1/0/7-1/0/28 (Untagged)

VLAN 2:

Ports: 1/0/2, 1/0/3 (PVID = 2, Untagged), 1/0/6 (Tagged)

VLAN 3:

Ports: 1/0/4, 1/0/5 (PVID = 3, Untagged) , 1/0/6 (Tagged)

WNDAP330

Management VLAN = 1

Management IP = 192.168.0.235

SSID “VLAN2” (VLAN ID = 2), Open system None

SSID “VLAN3” (VLAN ID = 3), Open system None

LAN to 1/0/6

DGFV338 LAN to 1/0/2

Internet

DGFV338

LAN IP: 10.0.0.1/24

DHCP 10.0.0.0/24

1/0/4 to LAN

Corporate LAN

1 2 3 4 5 6 7

Version 1.0 1

Résumé du contenu

Page 1 - Version 1.0

Version 1.0 Layer 2 / Layer 3 switches and multi-SSID multi-VLAN network with traffic separation This document describes the steps to undertake

Page 2

Version 1.0 Table of Contents NETWORK SETUP ...

Page 3

Version 1.0 NETWORK SETUP Physical setup DGFV338 connected to port 1/0/2 on Layer2/Layer3 switch Corporate LAN connected to port 1/0/4 on

Page 4

Version 1.0 LAYER2/LAYER3 SWITCH CONFIGURATION Create a new VLAN Access the VLAN configuration via Switching, VLAN, Basic. Input the

Page 5

Version 1.0 Save the configuration Access the Save Config page via Maintenance. Tick the box appearing within the Save Configuration option

Page 6

Version 1.0 ACCESS POINT CONFIGURATION Enable the Wireless Radio mode and configure the Radio Channel Enable the Radio (by default its turne

Page 7

Version 1.0 FURTHER NOTES Testing Testing can be performed by connecting a Wireless client to each of the SSID alternatively (i.e. VLAN2, VLAN3) a

Commentaires sur ces manuels

Pas de commentaire

Netgear WNDAP330 Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Mise en réseau Netgear WNDAP330. Netgear WNDAP330 Reference Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Mise en réseau Netgear WNDAP330