Netgear WG103 Note d'application télécharger pdf

Version 2.0

UTM (Unified Threat Management) in a multi-SSID multi-VLAN network with

traffic separation

This document describes the steps to undertake in configuring a UTM 10 (Firmware version

1.0.16-0) and a WNDAP330 (Firmware version 3.0.3) to host a multi-SSID and multi-VLAN

network.

The solution will allow separating the Wireless traffic and Wired traffic of each of the VLANs

configured, from any other VLAN which will exist on the Wired or Wireless LAN – maintaining

same VLAN communication.

The diagram below shows a typical scenario.

AP configuration (WNDAP330)

LAN IP

192.168.1.235

Untagged VLAN: 1 – Management VLAN: 1

SSID Corporate – VLAN 1(ID 1)

SSID Guest – VLAN 20 (ID 20)

SSID Engineering – VLAN30 (ID 30)

Corporate

Guest

Engineering

UTM Port 1 to AP LAN

UTM 10 Configuration

LAN IP

192.168.1.1

VLAN1 (Corporate - default)

IP 192.168.1.1

Membership: Port 1, 2, 3, 4

DHCP enabled 192.168.1.x/24

VLAN20 (Guest1)

IP 192.168.20.1

Membership: Port 1

DHCP enabled 192.168.20.x/24

VLAN30 (Engineering)

IP 192.168.30.1

Membership: Port 1

DHCP enabled 192.168.30.x/24

UTM Port 2 to Switch 0/1

Internet

Wired LAN 192.168.1.x/24

Layer 2/ Layer 3 switch configuration

LAN IP

192.168.1.239

Management VLAN: 1

Membership : all ports Untagged in

VLAN1

1 2 3 4 5 6

Version 2.0 1

Résumé du contenu

Page 1 - Version 2.0

Version 2.0 UTM (Unified Threat Management) in a multi-SSID multi-VLAN network with traffic separation This document describes the steps to und

Page 2

Version 2.0 Table of Contents Network Setup ...

Page 3

Version 2.0 Network Setup Physical setup Layer 2/Layer 3 switch Port 0/1 connected to UTM10 Port 2 Wireless AP LAN port connected to UTM10 Port

Page 4

Version 2.0 UTM10 Configuration Create a new VLAN Access the VLAN configuration via Network Config, LAN settings, LAN Setup. VLAN1 exists o

Page 5

Version 2.0 AP configuration (WNDAP330) Create a new SSID Access the AP configuration via Security, Profile settings (by default all

Page 6

Version 2.0 Further Notes Testing Testing can be performed by connecting a Wireless client to each of the SSID alternatively (i.e. Corporate, Gue

Commentaires sur ces manuels

Pas de commentaire

Netgear WG103 Note d'application

Naviguer en ligne ou télécharger Note d'application pour Mise en réseau Netgear WG103. Netgear WG103 Application Note Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Mise en réseau Netgear WG103